The visible water is gone, the carpet looks fine, and someone told you a couple of fans would finish it off. But the studs behind the drywall are still reading wet, the subfloor is holding moisture, and the house smells a little off. Structural drying is how you get the framing, subfloor, and walls truly dry before anything gets closed up.
Free referral to independent, licensed and insured local pros. Zip codes served include 70090.

We are a referral line, not a contractor. Calls are routed to independent local pros around Wallace who treat drying as a measured process with daily readings and written logs.
Low-grain refrigerant dehumidifiers pull moisture to levels standard units cannot reach. Desiccant units handle cold spaces and dense materials. Air movers are placed at specific angles to sweep moisture off wet surfaces.
The contractor records temperature, relative humidity, GPP, and material moisture each day, then adjusts equipment based on the numbers.
Each contractor runs an independent, licensed and insured business. Confirm both with the pro before equipment is set.
You will see equipment day rates and an estimated drying timeline before setup.

Good drying starts with a moisture map and ends with readings that match dry standard. Everything in between is about controlling air, temperature, and humidity.

Meters and thermal imaging trace water into hidden spots before drying begins.
Sealing off the wet area with plastic focuses the equipment and shortens drying time.
Small holes behind baseboards let injection systems push dry air into wall cavities, which can avoid tearing out drywall that is otherwise sound.
Hardwood and subfloors are dried with mats and controlled airflow to reduce cupping.
Drying ends only when readings confirm the structure is dry, and you get the log for your records.
Tell the dispatcher when the leak happened and what has been done so far.
The pro arrives with moisture meters, infrared camera, and drying gear.
The pro maps moisture, records dry standard from unaffected areas, calculates equipment needs, and gives you a written estimate.
Equipment runs with daily readings and adjustments until every material reaches dry standard, then it is removed and the log is handed over.
Closing up wet framing is how mold starts.
A week of box fans did nothing. The pro found wet framing with infrared and dried it properly in four days.
Laura F.Hidden wet framing after leakWall injection drying saved our drywall. Just a few small holes behind the baseboards.
Kevin Y.Wall cavity dryingI liked seeing the daily log. Humidity numbers, wood readings, all of it. The adjuster liked it too.
Mariah S.Insurance drying documentationOur oak floor was cupping. They used floor mats and kept the drying slow and steady. The boards flattened back out.
Henry L.Hardwood floor drying

Typically three to five days, longer for hardwood, plaster, or concrete.
Consumer equipment is too weak to dry framing quickly enough to prevent mold.
Dry standard is the normal moisture reading of the same type of material in an unaffected part of the home. Drying is complete when wet materials match it.
Grains per pound, or GPP, measures how much water vapor is in the air. Lowering GPP in the drying area speeds evaporation from wet materials.
It is loud and warm. Closing off the drying area helps at night.
No. A Water Damage is a free referral service that connects you with independent, licensed and insured local contractors who perform the drying.

Calls from Wallace and zip codes such as 70090 are routed to structural drying pros working locally.
See nearby cities in the list below.
